
Okay, so I made this at one of my hall activities, and it was so fun and easy!
Step 1: cut three strips of paper, we used the 12x12 cardstock. cut one strip 1.5", 2", and 3", so you should have three strips of paper (each will be 12" long)
Step 2: cut into each strip, leaving a little more than a 1/4" from the top and cut narrow strips about 1/8" apart, throughout the whole big strip; on all three
Step 3: put the face side up on the 1.5" strip, put two glue dots along the edge, place a piece of about 18 gauge floral wire, my wire was about 18" long, in the glue dots, and roll the strip tightly around the wire. secure it at the end with another glue dot. Do the same for the 2" strip ...roll it right on top of the 1.5" strip, face up so it will show when you spread it out at the end. Again, secure it with a glue dot and then do the same for the 3" strip.
Step 4: put some glue dots around the base, and then use light green floral tape to wrap around the stem and tuck in the ends under the base, and then use the tape to wind around the wire to make it look like a stem.
Step 5: you can either "smash " the flower head into the table to spread it out, or use your fingers to separate the petals. the flower should be about 4" across.

this is the stem, and back of the flower.

This is the head of the flower. You can use three different kinds of paper, or the same.
A close up of the flower, but they are really cute!